| Visual check of mains electrical switches, wiring and/or conduit (cracks, broken controls etc.) |
|
|
|
| Verify all guards are secure and function correctly (check latches, locks, fasteners and/or interlocks). |
|
|
|
| Ensure workspaces and walkways are clear and unobstructed, and that
no slip-hazards are present. |
|
|
|
| Confirm availability and condition of personal protective equipment. |
|
|
|
| Visually check that the air receiver drain tap is closed before operating. |
|
|
|
| Conduct any daily checks as required to the manufacture specifications. |
|
|
|
| Conduct close inspection for damage to switch gear. Test operation of switch gear (proper function of switch controls). |
|
|
|
| Check and drain the moisture from the air receiver tank. |
|
|
|
| Check and clean air filters if required. |
|
|
|
| Check availability of spare parts e.g. air filters, air hose and fittings, etc. |
|
|
|
| Check air filters and replace if required to manufacturer’s specification. |
|
|
|
| Check that the gauges and air receiver drain tap are functioning. Adjust, repair or replace as needed. |
|
|
|
| Clear away all dust, fines, grit, and waste from inside and around housings, cabinets etc. |
|
|
|
| Examine drive belts for flaws and correct tension – adjust if necessary. |
|
|
|
| Check security of all fixed guards. |
|
|
|
| Examine bolts used for mounting the motor to the machine. Re-tighten if necessary. |
|
|
|
| Check the security of machine mountings to the floor or base block. |
|
|
|
| Service and lubricate the compressor as per the manufacturer’s specification. |
|
|
|
| Check condition of 50mm line markings defining operator zones and access walkways. |
|
|
|
| Review safety operating procedure and update if necessary. |
|
|
|